Install Antennas
The EZR26-5G router uses MIMO antennas on both 5G and Wi-Fi connections.
Last updated
The EZR26-5G router uses MIMO antennas on both 5G and Wi-Fi connections.
Last updated
Please check the chart and image below about which antenna goes to which socket.
4x Mobile (Side Panels)
5G-NR Antenna
3x Wi-Fi (Back Panel)
Wi-Fi 6
The mobile antennas are wide paddle antennas with the printed mark "5G-NR Antenna." Their antenna sockets are on the left and right side panels, and they have "Mobile" marks.
The thinner Wi-Fi whip antennas have the printed "Wi-Fi 6" mark on the top end. The "Wi-Fi" antenna sockets are on the back panel.
To install the antennas, twist the connectors clockwise onto the router until they are securely fastened. Then, connect the antennas to the correct sockets, as shown in the image below.
Only twist the connectors; do not excessively turn the antenna bodies, as this could damage the antenna pin or internal wiring. All the antennas have vertical polarization. Once installed on the router, ensure all antennas remain upright and vertical for the best possible reception and range.
The flat panels of the 5G paddle antennas have a higher performance. Please adjust the paddle direction towards the outside or signal source to receive a better signal.
To ensure optimal performance of your 5G router, position the device away from potential sources of radio frequency interference, such as microwave ovens, radio transmission equipment, and high-power electrical appliances.
